Name is required.
Email address is required.
Invalid email address
Answer is required.
Exceeding max length of 5KB

DSC PowerSeries PC1864: Revision Number Needed to Use Telular Home Control?

Adrial Solium — Mar 13, 2015 03:43PM EDT

What revision number do i need on my DSC PowerSeries PC1864 wired security system in order to utilize Telular's Home Control Interactive Monitoring Services with GEOARM? How would i go about adding z wave capabilities to the mix?


1 Community Answers

HelpDesk5 - Mar 13, 2015 at 03:44PM EDT

GEOARM Security Agent

In order to do Home Control Interactive monitoring with your panel must be revision 4.5 or higher and you must have a tl260r internet communicator, 3g2060r cellular communicator or a TL2603GR dual path communicator. If you are looking to add Home automation to the mix than you must also in addition have a asg1000-1t5nas hub which the link can be found below.

If you system revision number is lower than 4.5 you must swap your panel board for a newer one which you can find the link underneath this message. Or contact us for alternate options for an different interactive interface 1-877-443-6276

DSC PC 1864 : http://www.geoarm.com/pc1864-dsc-powerseries-alarm-control-panel.html

Monitoring: http://www.geoarm.com/telular-cellular-interactive-alarm-monitoring-home-control-for-dsc-security-systems.html
HUB : http://www.geoarm.com/asg1000-1t5nas-interactive-telguard-homecontrol-hub.html
Internet Communicator : http://www.geoarm.com/tl260r-dsc-powerseries-broadband-internet-alarm-communicator.html
Cellular Communicator : http://www.geoarm.com/3g2060r-dsc-connect-24-wireless-cellular-3g-alarm-communicator.html

rated : 0 Up Down

Post Your Public Answer