Powerline Carrier Device Programming

ZT16 is only available on the LynxSIA Plus version of the control panel.

1) Enter Installer Code on the panel while disarmed (Default 4112) + 800


2) You Will now see 20 INSTALLER CODE if that was the correct installer code.

3) Press *80

Entering “0” exits mode, upon which this prompt blinks, indicating that the mode is
inactive. Entering “1” advances to the next prompt below. 

SELECTIONS
0 = exit mode
1 = enter mode

4) Press *99 After the screen updates to the next field to exit programming

Note: GeoArm can change the installer code upon activation

Follow Install manual for more information: 
https://turbifycdn.com/ty/cdn/yhst-51756635596032/l3000-honeywell-lynx-plus-wireless-control-panel-installation-and-setup-guide.pdf