Dynamic Signaling Delay

1) enter Installer Code into a PROGRAMMING KEYPAD ONLY (Default 4112) + 800

2) enter *54

3) Enter Desired Field (Input guide will be posted below this)

Inputs:

Select delay from 0 to 225 secs, in 15-sec increments.
 0 = no delay (both signals sent)
1 = 15 secs
2 = 30 secs
etc.

6 = 90

15 = 225

6 is a typical number set in this field

4) enter *99 to exit programming

Note:
The Vista 15P does not have partitions, any fields dealing with partitions will not be available on the Vista 15P

Programming Manual For More Information:

https://turbifycdn.com/ty/cdn/yhst-51756635596032/honeywell-vista-20p-control-panel-programming-guide.pdf

GeoArm can assist in changing the installer code upon activation.