Default Panel - Reset Panel - Back Door

To Default the panel back to factory

There are 2 different type of defaults

Soft Reset - will allow you to only default certain feilds on the panel such as the zones and the console from the panels touch screen

Hard Reset - This will be a full factory reset and can be done with a couple more steps.

NOTE: Defaulting the panel will wipe out memory that you have input into the panel. Do Not default the panel unless you understand you will have to reprogram your panel.


SOFT RESET:

1) Enter the Toolbox with your installer code (Default is 1561)

2) Enter The Installer Tool Box on Page 3

3) Press Restore Defaults

4) Select what you would like to default and then select restore defaults


HARD RESET:

1. Remove the Control Panel cover and completely
disconnect all power to the Control Panel.

2. On the inside back of the Control Panel, plug in the
backup battery.

3. Tap and hold down the Emergency "+" and Home ▬
buttons.

4. Continue to hold down the Emergency + and Home ▬
buttons and then connect DC Power to the Control
Panel.

5. Release the buttons only after both the Emergency "+"
and Home ▬ buttons are lit and the control panel screens appear.