Disable Auto Stay Arming - Enable Auto Stay Arming

(This field applies only to the LynxSIA Plus control)

1) Enter Installer Code on the panel while disarmed (Default 4112) + 800

2) You Will now see 20 INSTALLER CODE if that was the correct installer code.

3) Press *57 to begin changing false alarm options

Enter either of the follow options to change select settings

       Cancel Alarm Display | Auto Stay Arming | Exit Time Restart/Reset
0 =        Disabled                           Disabled                       Disabled
1 =        Disabled                           Disabled                       Enabled
2 =        Disabled                           Enabled                         Disabled
3 =        Disabled                           Enabled                         Enabled
4 =        Enabled                            Disabled                        Disabled
5 =        Enabled                            Disabled                        Enabled
6 =        Enabled                            Enabled                         Disabled
7 =        Enabled                            Enabled                         Enabled 

4) Press *99 After the screen updates to the next field to exit programming

Note: GeoArm can change the installer code upon activation

Follow Install manual for more information: 
https://turbifycdn.com/ty/cdn/yhst-51756635596032/l3000-honeywell-lynx-plus-wireless-control-panel-installation-and-setup-guide.pdf