Power Up In Previous State

1) Enter Installer Code on the panel while disarmed (Default 4112) + 800

2) You Will now see 20 INSTALLER CODE if that was the correct installer code.

3) Press *39

Note: If the previous state was Armed Away or Stay, the system will not respond to sensor
changes for 1 minute. This allows time for sensors such as PIRs to stabilize.

UL installations: must be 1 (power up in previous state) 

0 = always power up in a disarmed state
1 = assume the system status prior to power-down

4) Press *99 After the screen updates to the next field to exit programming

Note: GeoArm can change the installer code upon activation