- Support Center
- Honeywell
- L3000 Lynx
-
GeoArm
-
GeoAlarm
-
2GIG
-
M2M
-
Qolsys
-
FBI
-
Honeywell
-
Alarm.Com
- App
- FAQ
- ADC-SEM-100-LTE
- ADC-SEM110-PS-VZ
- ADC-SEM210-PS-AT
- ADC-SEM210-PS-TL
- ADC-SEM210-PS-VZ
- ADC-SEM300-PS-AT-M
- ADC-SEM300-PS-VZ-M
- ADC-SEM110-VT-VZ
- ADC-SEM210-VT-VZ
- ADC-SEM210-VT-AT
- ADC-SEM210-VT-TL
- ADC-SEM300-VT-VZ
- ADC-SEM300-VT-AT
- ADC-SEM300-VT-AT-M
- ADC-SEM300-VT-VZ-M
- ADC-V515
- ADC-V523X
- ADC-V723X
- ADC-V724X
- ADC-V821
- ADC-VC727P
- ADC-VC728PF
- ADC-VC827P
- ADC-VC838PF
- ADC-VC847PF
-
Alula
-
DSC
Programmable Tone Generation Time
1) Enter Installer Code on the panel while disarmed (Default 4112) + 800
2) You Will now see 20 INSTALLER CODE if that was the correct installer code.
3) Press *78
This field is used to set the time delay between when a connection is established on a
Radio (digital communication with voice capabilities) session to when the 2100 Hz
“training” tone is terminated. Enter any digit between 00 and 99.
Note: This field only applies when a GSMVL radio is installed in the control. Otherwise, enter “00” to
disable.
SELECTIONS
00 = Disabled
01-09 = 100-900 ms
10-99 = 1.0 – 9.9 secs.
4) Press *99 After the screen updates to the next field to exit programming
Note: GeoArm can change the installer code upon activation
Follow Install manual for more information:
https://turbifycdn.com/ty/cdn/yhst-51756635596032/l3000-honeywell-lynx-plus-wireless-control-panel-installation-and-setup-guide.pdf
