How to Install the Lyric Controller on a Desktop

For desktop mounting of the Honeywell Lyric controller use the Lyric Desk Stand (LCP500-DK) it is installed in place of the wall mount. The desk Stand can be installed in two positions that provide a viewing angle of 30 degrees or 60 degrees.

Follow the steps and refer to the figures below :

Replace the Back Plate

1. Remove the screw securing the rear cover to the controller.

2. Remove the rear cover.

NOTE: If using the high-capacity (24-hour) backup battery (Kit LCP500-24B, battery p/n 300-03866-AIO), remove the battery retainer clip. The clip is not required when the desk mount is installed.

3. Feed the field wiring through the appropriate openings in the rear cover included with the Lyric Desk Stand (LCP500-DK).

4. Install the new rear cover.

5. Install the screw to secure the rear cover to the Lyric Controller.

Install Desk Stand

1. Align the slots on the back of the Lyric controller with the hooks on the desk stand as shown below.

2. Insert the stand into the slots on the rear case to provide the desired viewing angle and slide up to lock in place.