Program A Sensor - Auto Learn Mode

There will be videos attached for most sensors below instructions


1) Tap on the grey bar at the top middle of the screen

2) Tap Settings

3) Tap Advanced Settings

4) Enter either, Installer(Default 1111), Dealer (Default 2222)

5) Tap Installation

6) Tap Devices

7) Tap Security Sensors

8) Select Either "Add Sensor" or "Auto Learn Sensor"

Auto Learn Sensor:

1) Open the cover tamper for the device or press the tamper button inside the sensor when needed

2) Sensor will be displayed on the screen, confirm the information and continue.

Add Sensor:

1) Fill out the information needed for the sensor that is currently being programmed in

Note: GeoArm recommends using "Auto Learn Sensor" as it is much friendlier to DIY installers

Enroll PG9914 Motion Detector: 



Enroll PG9945 Contact:



Enroll PG9939 Key Fob: 



Enroll Power G Sensor:



Enroll IQ Light Bulb: 



Enroll QS5110-840 Smoke Detector: 



Enroll IQ Carbon: